Specifications

one of the leading container house manufacture , more than 10 years experience , extra wide container home

 

The   container will conform to the following standards in their latest   editions.
No.1:Handling of the Worker Dorm Type 1
The container will be constructed to be handled under the   following conditions without any permanent deformation or effect on its   structural in
(1) Lifting full by its top corner castings by means of   spreaders.
Bitmap                    (2) Lifting full by its bottom corner castings by means of     fitting at a sling angle of 30 degrees.
No.2:Technical parameter of Container dorm.
1)Roof Load: 0.5 KN/sqm
2)Wind Speed: 210km/h
3)Temperature: -50°C-+70°C
No.3:Dimensions of Work   Dorm .
		Length		Width		Height		Remark
20HC		6058mm		2438mm		2896		Exterior   Dimension
		5800mm		2250mm		2750mm		Interior   Dimension
No.4:Handling of the Worker Dorm Type 1
The container will be constructed to be suitable for   transportation in normal operating conditions by modes of:
(1) Marine-on deck or in   cell guided by vertical or diagonal lashings
(2) Rail-on flat or   container car secured at its bottom corner castings
No.5:Ratings of Work Dorm   dorm.
		Max   gross weight(kg)		Tare   weight(kg)		Payload(kg)		Remark
Worker   Dorm Type1		15000		2000		12000
No.6:Specification of work Dorm Type 1 steel structual
6.1. Base and Floor     The floor is composed of cross-member ,floor plate and bottom   side rail.         Bottom end / side rail                 t4.0m thick, SPA-H     Floor Plate                                   t18mm   thick, PLYWOOD     Cross-member                             t3.0mm   thick,       SPA-H         2) ROOF:     Frame   construction: 6mm welded steel   profile;     Roof Panel: t1.6mm thick, SPA-H     Top end   / side rail:       t3.0mm   thick, SPA-H         3) CORNER POSTS:     Profile: Cold rolled 4.0 mm steel   profile..         4) WALL PANELS:     Side Panel: t1.6mm thick, SPA-H         PRESERVATION         All the surface of the assembled container will have coating system as   follows:         Exterior Surface Epoxy zinc rich primer 30     Epoxy   primer 40     Acrylic topcoat 40            Total 110     Interior Surface Epoxy zinc rich primer 30                        Acrylic   topcoat 40                          Total   70
No.7:Container dorm.   Decoration Information
1) Wall and Celling: Insulation material plus board
2)Floor:18mm plywood floor ,
3)Insualtion material:EPS
4)Window:Plastic steel
5)Door:Security door