Semi-topping gear hobs

When ordering ,please provide data as follows:

1.Module or DP

2.Pressure angle

3.Teeth No. of gears ,usually No. is 35.

4.Chamber amount of gear .

5.Special request can be taken to design .

6. This kind of hobs can cut out gear tooth profile and tip relief simultaneously

7. When ordering, please offer data as follows:

1)    Module or diametral pitch m or D.P.

2)    Pressure angle P.A.

3)    Teeth of gear manufactured Z , in usual condition Z=35

4)    Chamfer amount of gear , usually C=0.08m along circle f=0.10m along radius

8. Special requirement can be taken to design.