Specifications

Water for Injection Plant, Ointment Manufacturing Plant
, Lotion Preparation Plant, Pharmaceutical Manufacturing Plant

Water for Injection Plant is designed to produce sterile, pyrogen free distilled water conforming to U.S.P. / B.P. specifications. The still works on interstate heat exchange principle whereby the distillate is produced at a fraction of the cost as compared to single column stills. All contact parts are made out of AISI 316 quality and mirror polished.

It is available from 50 liters/hr (Lab Model) to 3000 liters/hr. The WFI produced by these plants is quite economical due to low maintenance and low operational cost

Salient Features

• 100% pyrogen free distilled water conforming to U.S.P./B.P. specifications.
• High initial cost but low operational cost.
• Saving up to 70% of energy as compared to single column stills.
• Low on maintenance as no moving parts except feed pump.
• The unit can be operated at a higher steam pressure to get upto 50% higher output.
• Automatic dumping of sub-standard distillate.
• Low level controls for feed water.
• Conductivity meter to continuously monitor the quality of final distillate.

Technical Specification

 

Material	All contact parts are made out of AISI 316 quality. All tubing is seamless
Sealant	P.T.F.E.
Distillate Quality	As per U.S.P. / B.P. specifications
Distillate Temp.	95°C
Feed Water Quality	De-Ionized mineral water with a max. conductivity of 5 micro Siemens / cm²
Feed Water Pressure	1kg/cm2 higher than the boiler steam pressure
Cooling Water	Normal tap water, hardness less than 90 PPM of CACO
Steam	Saturated dry, free from oil, vapors and other impurities

Note:

• Electrical characteristics can be adjusted as per customer’s domestic power requirements
• Rights of technical improvement & modification reserved.
• Illustrations & dimensions are shown for information purpose only

c