Specifications

Filling Machine For Dry Powder & Syrup
Dry Injection Filler
Dry Powder Filler
Syrup Powder Filling Machine
Powder Filler

Filling Machine For Dry Powder & Syrup

 

The filling head is mounted on machine's top plate. When bottle comes to the filling station it will be hold by the pneumatic bottle holder and immediately the bottle sensor pass the sense to sensor magnetic clutch which is mounted on auger shaft and starts to rotate. It will fill desired amount of powder into the bottle through auger. After filling, the piston goes back and releases the bottle on conveyor. The most important part in auger filling machine is the pneumatic bottle holding system which is directly connected with the auger rotation. It does not release the bottle until the bottle gets filled with powder as per set value.

Features

• Fully compact cGMP model
• No Bottle – No Fill, so No wastage of powder
• High quality motor is used for moving conveyor
• Speed can be adjusted so it is time saving
• Single track for bottle so semi person can easily operate the machine
• Pneumatic bottle holding system eliminates chances of bottle transfer until bottle gets filled
• Total PLC control for machine
• Not required to change the parts

Best Suitable For

• Dry Syrup
• Powder Chemicals
• All types of Powders

Utilities (To be Provided by Buyer)

Pneumatic Air:

Filtered, oil free, sterile low pressure AIR at 6 kg/cm2

Basic Machine

• Imported Gear Motor for Conveyor drive.
• A.C. Frequency drive for Conveyor drive.
• "No Bottle, No Filling" System.
• PLC control for machine.
• Pneumatic bottle holding system.

Machine Specifications

Model No. :	AAF-60
Direction :	Left To Right
Production Rate :	Up to 30 to 40 Bottles / Min
Fill Capacity :	10 grms to 50 grms. (with different set of Auger and funnel) Fill range depending upon Bottle opening and bulk density   of powder.
Accuracy :	± 2% depending upon consistency and the Uniformity of bulk density of powder Under controlled level of Humidity (i.e.   35%)
Electrical Supply :	1.00 HP For Main Drive   0.25 HP For Conveyor.
Power Requirement :	440 Volts, 3 Phase (4 wire System) 50 Hz.
Height of Conveyor:	Adjustable from 850 to 900 MM
Dimensions:	1524 MM (L) x 1105 MM (W) x 1800 MM (H)
Net Wight :	400 KGS. (Approx.)
Gross Weight:	600 KGS. (Approx.)

Input Specification

Bottle Conveyor:	25 mm To 70 mm MAX.
Height	55 mm To 110 mm.