Specifications

1.Brand: Hakko
2.Model:936
3.Antistatic
4.Output Voltage:24V AC
5.Dimensions:120(W) x 93(H) x 70(D)mm

HAKKO 936 Soldering Station

 

Specification

Name	HAKKO 936
Power Consumption	100, 110, 220-240V / 60W, 120V / 65W

 

Part list

 

 

Names of parts

 

 

 

Soldering Iron

 

	900S 900S-ESD	907 907-ESD	908 908-ESD
Power Consumption	24V AC-50W
Tip to Ground Resistance	Under 2ohm
Tip to Ground Potential	Under 2Mv (TYP 0.6Mv)
Heating Element	Ceramic heater
Cord Assembly	12.m (4ft)
Total Length(w/o Cord)	176mm (7in)	190mm (7.5in)	200mm (7.9in)
Weight (w/o Cord)	25g (0.06Ibs)	44g (0.09 Ibs)	54g (0.12Ibs)

 

Station

	936 Station / 936 Station ESD
Output Voltage	24V AC
Temperature Rang	200 – 480°C / 392 – 896°F
Dimensions	120(W) x 93(H) x 70(D)mm
	4.7(W) x 3.7(H) X 6.7(D)in
Weight (W/O Cord)	1.300g (2.9Ibs)

 

Maintenance

1. Set the temperature to 250°C(482°F)

2. When the temperature stabilizes, clean the tip with the cleaning sponge and check the condition of the tip.

3. If there is black oxide on the solder plated portion of the tip, apply new solder (containing flux) and wipe the tip on the cleaning sponge. Repeat until the oxide is completely removed. Coat with new solder.

4. If the tip is deformed or heavily eroded, replace it with a new one

 

Calibrating the Iron Temperature

1. Connect the cord assembly plug to the receptacle on the station

2. Set the temperature control knob to 400°C(750°F)

3. Turn the power switch to “ON” and wait until the temperature stabilizes. Remove the CAL potentiometer plug.

4. When the temperature stabilizes, use a straight-edge screwdriver or small plus (+) screwdriver to adjust the screw (marked CAL at the station) until the tip thermometer indicates a temperature of 400°C(750°F). Turn the screw clockwise to increase the temperature and counterclockwise to reduce the temperature. Replace the CAL pot plug.

 

More picture on HAKKO Tools