Specifications

Automatic air shower for clean room
1) Automatic blowing
2) Electronic interlock
3) Microcomputer control circuit board
4)

ZS-FL-1300 Automatic air shower for clean room

Description:

Air Shower is a kind of partial clean equipment with rather strong universality and is installed at the partition between the clean and non-clean rooms. Its used for the personnel or matters to shower before entering the clean area. After using it, the dust could effectively be reduced to enter the clean area and maintain the normal working status.

 

Material:

 

 

Outside case: 1.2mm cold rolled steel with powder coated or staniless steel(SUS#201 OR 304)

Inside case: 1.2mm cold rolled steel with powder coated or staniless steel(SUS#201 OR 304)

Doors: SUS#201,SUS#304 or aluminum alloy

Base: SUS#201 or 304

Nozzles:SUS#304

 

Features:

1. The control system:LCD control panel, electronic interlock, and automatic blowing

  (One door in open state, the other door must in close state. When people enter air shower, the system will shower automatically by photoelectric sensor)

2. Air shower time from 0 to 99 seconds which can be adjustable

3. Adopt Pre filters and HEPA filters

4. The case adopts high quality cold steeling rolling plate with powder coated

5. The door, bottom-board, nozzles are used of stainless steel, good appearance.

6. when air shower is used to pass cargo, it is without bottom-board.

 

Optional accessor

1.Automatical door by photoelectric sensor ( when person enter air shower, the door will open automatically, go out air shower, the door will be closed automatically.)

2.HEPA filter or ULPA filter

3. The case is used of cold-rolled steel plate / all stainless steel air shower / just stainless steel inside

4. Common fluorescent lamp / UV Sterilizer lamp   

5.  With voice announce