Specifications

TAIYITO TDX4487B fingerprint door lock
le phone control function
2.remote control
3.MOQ:1pc
4.Warranty:1 year

 TAIYITO TDX4487B fingerprint door lock with mobile phone control function

 ---You could control the door lock with your mobile phone.

 

Technical specification

Unlocking ways:fingerprint,remote/code,emergency keys

Technical support:  Q/HSY 001 standard techniques, Fingerprint living collection technology researched and developed by United States TI company.

The received signal sensitivity:  -90dB

Work voltage: four 1.5 volts alkaline batteries corresponding with International standard, 6 volts DC.

Battery life: >8 months

Unlocking time:<1s

Unlocking hint:red light flash and greeblight become bright.After green lignt extinguishs,the door latch automatically.

Sub-standard voltage: <4.5V,red light flash and alarm when you open the door(it can still work for hundreds of times)

statical power consumption:<180uA

Dynamic Power:150mA—250mA

The working temperature: -10°C---50°C      

The working humidity:10%RH--90%RH

Fingerprint capacity:32/120

FAR:<0.0001%

FRR:<0.01%

Resolution ratio:500dpi

Confirmation  time:<1s

Remote distance:3-8/3-30/3-100m(in 360 degree range)

Fingerprint setting:correct match in 360 degree,twice can generate a master plate

Fingerprint update:Completely automatically updating technology

Whether to accept light interference:Accept external light

Collecting time:<0.5s

Sensor:CMOS 300 thousand pixel

The storage temperature:-20°C---60°C

 

 

 

 

Installation instruction

1,  Perforate on the door according to the installation diagram

2,  Instal the mortise lock before linking the power line and communication line

3,After plug the square rod into the square hole on the front panel,put the board on the door,and then put the wire into the hole.

Notice:If  the square rod doesn’t touch the bottom of the hole,the lock won’t be unlocked.Please pay attention.

4,Put the top spring of square rob into the hole in the back doorknob,afterwards harness the square rob and screw on the screw.

5,screwing the top and bottom screws not too tight and hold the front and back panels upwards and then tight the screws.

Notice: Square rob is the central shaft which must be adjusted to the centre lock hole,otherwise the lock will be stucking or the doorknob could’t get back to the original position.

 

6,Please not cover the lid after the battery is set until you have testing the unlocking procedures by fingerprin,remotes/code and emergency keys.If the lock make you feel stucking and stagnant,please unscrew the screws and reset it to the best position.