Specifications

co-extrusion corrugated hose
1. Temperature:-60~+800;
2. Working Pressure: 2Bar~100Bar;
3. Size I.D:25mm~100mm.
4. Meet RoHS

 

 

co-extrusion corrugated hose

 

1. Constitute: Corrugated hose is extruded by hard bones and muscles frame and  environmental protection material (polyether ester) hard bar.

 

2. Key size:

    Telescopic part of the external wave 2 ~ 4 mm, pitch of wave from 3 to 6 mm; Internal wave 0.5 ~ 1 mm.

 

    Recommended length is 400 mm, 500 mm, 600 mm, 800 mm, 1000 mm, 1200 mm, 1400 mm, 1600 mm , 1800 mm, 2000 mm and 2200 mm, the length tolerance is L+50 0.

 

3. Characteristics: Corrugated hose extrusion skeleton is uniform and good toughness, the surface outside pipe is bright, clean and level off, without a scratch, crack, bubble, uneven, Ge nest, lack of glue, delaminating, double skin, NingJin, efflorescence, lack of material defects etc. affect the appearance and use of performance.

 

4. Applications: Widely applied in cable casing,construction drainage,agricultual drainage,irrigation,chemical industry,medicine and ventilation ducts etc.

 

5. Mark: OEM products are welcome.

 

key word	co-extrusion corrugated hose
Material	high quality import silicone/EPDM/PVC/TPU/TPV/TPE/PE
Size	Custom Design will be acceptable, wide size range can be accept
Color	blue,grey or customized
Adhesive strength, kN/m	≥1.5
Brittle temperature(-50°C×4h)	No craking
Ozone resistance,(50±5)mPa,(70±2)h×(40±2)°C	No cracks and visible change
Air aging(110°C×72h)	No cracks and visible change, hot air aging test after bending, radius should be less than 80 mm.
Out-of roundness	The roundness of the telescopic pipe is not greater than 5%, when the test after the bend radius (or repeated bending after 5 times) out of roundness is not greater than 10%.
Toroidal pressure resistant	When the pipe deformation 2mm in diameter, pressure should not be less than 120N.
Bending radius	Should be less than 60 mm (bending center to the expansion pipe); bending radius should be less than 80 mm after the hot air aging.
Fire resistance	Meet the GB 8410-2006 <the combustion characteristic of auto interior materials> A - 0 mm/min requirement.

 

 

 

WHY US?

 

1. Full technical support from material mixing to final product delivery.

 

2. On-time delivery with no compromise on quality.

 

3. High-quality product making with advanced equipment and techniques.

 

4. Above 10 years' experiences in rubber parts manufacturing.