Product Details

Specifications

copper expansion joint
1.CE&ISO CERTIFICATE
2.20years export experience
3.offer OEM production
4.delievery on ti

copper expansion joint

1.Introduction of rubber expansion joint :

1) Material	EPDM, NBR, NR, Polarity rubber
2)Construction	Inner core, Outer cover, Frame, Metallic ring, M. I. union or Carbon steel flange
3)Connector Approval	Flanged, flange type Threaded, Union type Rubber Joint
4)Type	Single sphere or arch, Double spheres or arch
5)Threads	DIN, BSPT, BSP, NPS, NPT, Metric, (ISO7/1, DIN 2999, ANSI B1.20.1)
6)Flange Drilled	BS, DIN, ANSI, JIS or others provided drawing samples
7)Surface	Galvanized, Epoxy
8)Normal Specification	DN32 to1200mm(1 1/4 to 48 inch); For threaded union connector only be DN15 to 80mm(1/2 to 3 inch)
9)Usage	Protecting piping and equipments systems from stress or motion
10)Application	Air, Pressurized air, Water, Sea water, Hot water, Oil, Acid, Alkali etc

Rubber Expansion Joints are designed for piping systems to absorb pipe movements, relieve stress, reduce system noise/vibration, compensate for misalignment/offset and to protect rotating mechanical equipment against start-up surge forces.

Because of rubber has superior capability in resistance of acid, alkali, oil, and electrolytic, Rubber Expansion Joint has become one of the alternatives of stainless steel and been successfully installed in tough demanding applications such as: Chemical/Petrochemical, Marine, Power Generation, Pulp/Paper, Steel Mills and Water/Wastewater Treatment.

2.Rubber expansion joint Features and Benefits

1, Versatile hand-built construction. Made in China
2, Absorbs directional movement
3, Absorbs vibration, noise and shock
4, Compensates for misalignment
5, Wide flowing arch design
6, Virtually eliminates sediment buildup
7, Economical fully molded construction
8, High vacuum rating (up to 30" Hg) can be supplied for certain sizes
9, Special grooved flange ring design, prevent rubber end pulling out

10, Solid galvanized steel floating flanges speed the installation time
11, High tensile aircraft cable is embedded in the raised face rubber ends to prevent pull out and avoids the sharp cutting edge of solid steel rings
12, No gaskets required; integrally rubber flanged design, no gaskets required, DIN PN10/16 drilling standard, other flange drilling available, including ANSI 150lb/300 lb, BS, and JIS

3.Technical conditions of rubber expansion joint

Type	I	II	III
Work pressure MPa(Kgf/cm2)	1(10)	1.6(16)	2.5(25)
Explosion Pressure MPa(Kgf/cm2)	3.0(30)	4.8(48)	5.5(55)
Vacuum KPa(mmHg)	53.3(400)	86.7(650)	100(750)
Applicable Temprature oC	-15~115 special to -30~250
Applicable Media	water,sea water,hot water,oil,acid,alkali etc