Specifications

mositureproof silicon sealants.
1.aging resistance.
2.Do not contain any solvent.
3.non-toxic and pollution-free.

mositureproof silicon sealants.

Operating instructions:

1. Clean surfaces: Is stuck or is been clean by the spreading surface reorganization, except rust stain, dust and greasy dirt and so on.

2. The glue: With a blade cut open the front part, cover on pointed tips mouth, with extrusion gun will glue crowded to already clean surface. Will be sticking surface to close up fixedly.

3.Solidification: Will paint the part sets in the air, lets its room temperature solidify 5-20min and watch to do, completely solidifies apparent thickness to decide(the 3mm thickness ,the room temperature 25°C, the humidity50%,24hours may completely solidify. Solidification limit thickness is 10mm).

Contains:  Poly (dimethyl silicone polymer); Silicon dioxide ; vinyl oximinoslae; calcium carbonate.

Matters needing attention;

1. The pressure connected to the applicator should be 0.2-0.4Mpa when using pneumatic applicator.

2. Please in well ventilated place is good, if contact with eyes or skin, please rinse immediately.

Store: Store in dry shade under 28 °C degrees away from children.

Main Characteristics of Silicone Rubber KDW-1536
Before cure	exterior	white/black
	viscosity                           pa.s	~
	surface curing time                  min	5-30
After cure	temperature-resistant                °C	-60~+250
	tensile strength                    Mpa≥	4
	elongation                          %≥	250
	shaw strength                         A≥	25
	sheating strength                   Mpa≥	4
	racking strength                    KN/m≥	5
	electrical surface resistivty        Ω≥	1×1014
	electrical volume resistivty         Ω.cm≥	5×1014
	specific inductive capacity         1MHz≤	3.5
	dielectric loss angle tangent value 1MHz≤	5×10-3
	insulating strength                 KV/mm≥	20
	maximum curing depth                  mm	7~10