1.Specification of Machine

l   Model No.: ADF-1200L1

l   Filling Material: lubricating oil/Resin/ Engine oil

l   Filling Weight: 1000kg/IBC DRUM

l   Filling Capacity: 1000L IBC DRUM

l   Filling Accuracy: ±0.1% F.S. (Accuracy depends on suitable adjustment of slow feeding and the stability and consecutiveness of liquid to spray gun

l   Filling Speed: 10 IBC DRUMS/hour (Depend on previous speed of feeding material, the previous speed of liquid must be 300L/MIN.)

l   Measure Method: Two-section Feed Control, Filling into drum on above liquid level

l   Material Connector: DN40 Rapid Flange Connector (Pressure of liquid feeding should less than 0.6MPa)

2.Machine Details

2.1   Electric Weighing Scale with Roller Conveyor

l   Weighing Range: 1200kg x200g

l   Weighing Table Size: 1500mm X1500mm

l   LOVOSC LP7110 Load Cell for pieces

l   JB-05 Load Cell junction box

l   Painted Steel Platform

l   Roller Conveyor with no motor driven

l   Weighing Area Size:1500mm(L)x1500mm(W)

l   Material of Machine Body: Painted Steel

l   Installation Mode: On Ground

2.2   Automatic Liquid Filling Machine

l   Φ1 1/2” FB type Two Stages pneumatic Filling Spray Gun (Material of Spray Gun is SUS 304, Sealing Material: polyvinyl fluoride), Attached Φ1 1/2” rapid connector for feeding material, which used for change material, fast disassemble.

l   Three-section infeed control, there is a foot valve at head of filling gun to improve filling accuracy and avoid rest of liquid overflow

l   Gas-collection hood used to collect flue gas, stainless steel 304 material

l   Offer anti-leak cup, stainless steel 304 material

l   Manual adjust spray gun height

l   Equipped with automatic promotion and demotion cylinders

l   Equipped with base of filling spray gun (Material: Painted stainless steel)

l   Included Anti-explosion pneumatic parts (pneumatic parts brand is AIRTAC)

2.3   Automatic Controller

l   Wall-hung type Control Box

l   ST510 Weighing Controller

l   MCGSTPC TPC7062Ti Operation Interface

l   FATEK FBS PLC programming control (Including RS232 modular)

l   Two-section liquid infeed weight control (fast-slow)

l   10 Product Preset, easy to edit

l   Automatic Stop and Alarm when no liquid

2.4   Other Requirement

l   Buyer should install the machines by themselves and seller can give them guide; quotation doesn’t include installation costs.

l   Buyer should prepare soft pipe and flange to connect with our machines to infeed liquid; Buyer should prepare pump to supply liquid to our machine and it should has reflux device; buyer should prepare separate power source AC380V, 3Phase/AC220V;1Phase; 50Hz; 20A and 4-6kgf/cm2 compressed air.