HDPE Heat Insulation Anchor Shooting Nail

Speciafication:

1. Insulation Anchor Shooting Nail

2. Manufacturer

3. Material: HDPE plasitc

4. Shooting insulation nail with seal.

Description:

According to the insulation board thickness, the  insulation fixging nails has various of specification. This is the sizes our factory can  do 25mm, 30mm, 40mm, 50mm, 60mm, 80mm, 90mm, 100mm, 120mm,140mm, 160mm,200mm. This is all the size we can do now, also our factory accept customization. If you have drawing, we can also open new moulds as you need.

Features:

1. Breakthrough traditional of insulation shooting nails limited, Provides newsolution programme for insulation system of construction;

2. Tight speed 10 times above than traditional drilling and ancher way,construction speed 6-8grain per minute;

3. Avoid complex steps of drilling, tight directly. And no dust of drilling producing;

4. Without power supply,conveinent and practical;

5. Suit for sand-lime bricks,concrete and steel substrates;

6. Applicable to all kinds of insulation materials, such as glass wool, rock wool and so on;

7. The low heat conductivity doesnot sffect the insulation effection;

8. No presure for insulation board;

9. Application of insulation thickness 30-20mm.

Material:

We use original HDPE material to ensure our insulation anchor nail in high quality.

Packing & Shipping: 

1. 500pcs or 1000pcs in one carton wrapped by plastic film, then packed into carton + pallet.

2. As customer's request.

Our other products: