Pneumatic diaphragm pump for ink, glue
USD $70 - $300 /Piece
Min.Order:1 Piece
Wuhan Jingchuang Tech Co., Ltd.
Pneumatic diaphragm pump for ink, glue (QSM-CJ602)
Application areas:
(1) Print industry: printing ink(acquosity,intaglio printing) ,impregnant(toluene, acetone, ethanol, etc),dope and glue solution, etc.
(2) Paper making industry: evaporation and cooking liquid, blanch liquid, dope, and glue solution, etc.
(3) Petroleum and chemical industry: all kinds of oil material, fuel, chemical material, acid and alkali, etc.
Technical references:
Work press :0.15~0.8MPa
Max transporting flux: 26.5L/min
Max transporting viscosity:1000 centipoises
Max absorbing-height: 8m
Linked-screw thread(outlet and inlet of medium):G1/2
Linked-screw thread(inlet of air): G1/4
Frame dimension: 190x140x235mm
Fixed foot-aperture: 9mm
Aperture distance:142×92mm
Work characteristics:
(1) Air-operated, without spark, adept to avoidable explosion situation;
(2) The flux of the medium can be regulated with infinitive stage through compressing the valve of air inlet.
(3) Self- lubrication, low consuming air, and can be used under the bump moving and installing.
(4) There is no impulse and wallop in the outlet of the medium, and serving liquid uniformly.
(5) The material of the bellows should be able to resist erosion, and then the bellows can transport all kinds of erosive mediums.
Work mechanism:
This bump separates the medium cavity from the left and the right gas room through the left and the right bellows. When the valve core of the diversion valve states on the right, then the compressed air enter the left gas room, and the compressed air in the right gas room is discharged. with the increasing press in the left gas room, the left bellows extrude towards the left, make the press in the left gas room increase, and the liquid in the cavity transports through the single valve , expel from the outlet, and then the right transporting cavity closes.
Then the valve core of the diversion valve moves towards to the left, begins the next period, and reaches the aim of transporting the medium.
Attention:
(1) The bellows in the bump are very fragile, so you should change another if the use time beyond 8 months.Otherwise,the medium will enter into the air-operated cavity and make the bump can’t work.
(2) The diversion valve of the bump matches assistant startup equipment (the startup pin).when the bump can’t startup or ceases work, you should close the inlet valve, press the startup pin with your figure, and open the inlet valve, then the bump can work in gear.
(3) When some suddenness happens to the bump, you should check the filter at the end of the transporting pipeline. If the filter is jammed, you should clean it.
Installation Explanations:
There are 4 feet aperture under the bump body, and the aperture distance is 135×95mm.The purpose of the feet- aperture is to fix the right position.
If the products of our company have some problems, we will answer for repairing or exchanging them in one year.
our company prepares for some frangible accessories on standby. If you want, you can communicate with us at any moment.
If you have any questions, just tell me, I will reply you asap.