Automatic sensor soap dispenser YK1022

Automatic Soap Dispenser is the use of digital circuit control, automatic infrared sensors and battery (or DC power supply) driven automatic spray disinfection / soap dispenser. It has a stable, reliable, strong anti-light interference, sensor sensitivity, etc; infrared sensors, automatic spray liquid, suitable for all kinds of disinfectant, medicine / hand sanitizer; low-power drive circuit design, the battery life more for a long time and is ideal for public places.

Product size: L125 * W108 * H258mm
Product Weight: 0.82kg
Packing: 24 / box
Carton size: L45.5 * W39.6 * H54.2
Carton Weight: 19.68kg
Carton Gross Weight: 21kg

 Features:

Automatic sensor -------------- prevent the spread of germs caused by contact.

Automatic power-saving chip -------- more energy, environmental protection, use of cost savings.

More humane design ----- easy to install, simple to use, long life.

Long battery life, while support for AC / DC power supply

Automatic continuous spray function, when the continuous sensor disinfection will spray 1 every 3 seconds
 Continuous spray nine times, automatically stop, re-induction, you can continue to work.
  
Part Name
  
1. Pump 2. mounting holes
3. Switch 4.AC Power Connector
  
5. Cap 6. Battery box
7. 8. The sensor container
  
9. nozzle 10. Indicator

 Use
1. Press (Figure I)  shown in the side shell open.
2. Press (Figure 2) in the installed position shown in size 4-φ6 drill mounting holes, and random
    The stopper comes stuffed with the supplied screws to fasten the installation of the product
    Position.
3. Press (Figure 3), the battery cover in the direction of the arrow pulled out into the four on the 2nd power
    Pool (1.5V), battery cover can. If you want to use AC power, you do not need
    Install the battery directly into 220V AC power outlet, and the other end into the electrical
    Pool inside the AC connector box can be.
4. Open the bottle, the disinfectant / hand sanitizer bottle poured into the bottle cap. Largest
    Amount 1000ML.
5. Initial use, hand press pump head several times to exhaust air pump body.
6. Closing above case, it can be used normally, when the indicator display is green, indicating
    In working condition.
7. When in use, place your hand under the nozzle out within 8cm range, the machine will automatically spray
    Liquid once every liquid discharge approximately 1ML. If the hand does not leave the sensor range, disinfection
    The fluid once every 3 seconds for 9 times to automatically stop and indicator lights
    Red give warning.

Technical specifications

  Rated voltage: DC4 × 1.5V Capacity: 1000ML
  Sensing distance: 8cm ± 1cm spray volume: 1ML / times
Notes

1. To prevent malfunction, leaving the bottom of the machine should be a minimum of 40cm space, do not place security
  Mounted above the strong sunlight to the place and highly reflective material.
2. Prevent any obstructions liquid outlet.
3. Keeping the liquid inside the machine clean and free of the other strip or block impurities.
4. Avoid direct the machine with water.
5. When removing the liquid in the container, if any, the product is prohibited flat, to prevent liquid outflow
   Wet motor, circuit board, causing damage, need to first liquid pouring to flat.
  
Packing List
  A machine
  A manual
  Screw package: automatic tapping screws 4, 6mm stopper 4.