Specifications

1.Extremely fast and hot
2.Extremely energy-efficient
3.Reacg high temp. in 10s
4.Meet Rohs requirement
5.Own factory

 1.Introduction:

It is a co-sintered ceramic heating plate that is made by printing a resistor on a sheet of

alumina ceramic. then rolled into a rod and sintered into one solid piece as a whole. Being

characterized by rapid Heat Increase, Custom designed temperature distribution available,

high levels of insulation allow direct contact with metal and water; Superior dielectric strength  

and volume resistivity; Longer life due to oxidation-proof design on resistive material and Superior chemical resistance, our ceramic heating element are widely used for hair straighter, soldering iron,

steam boiler, and other industrial application.

2.MCH VS. PTC

MCH is the abbreviation of Metal Ceramics Heater.

 

PTC is the abbreviations of Positive Temperature Coefficient .

 

MCH refers to print circuit on the surface of ceramic heater which consist of metal tungsten,

molybdenum manganese.Then co-fire via 1600 °C  high temperature .

It enjoy the following advantages over PTC.

 

.Extremely fast and heat(permanently higher than 800°C,and in a short time up to 1000°C)

.Extremely energy-efficient

.Resistant to thermal stress rapid switching is easily toleratedly.

.Can be regulated easily and seamlessly

Ceramic Heating Plate Usual Specification:

Dimension: accordingly

Voltage: 13V-230V 

Resistance: accordingly

Dielectric strength: 3750V, 5s, Leakage current ≤ 0.5mA 

Flexural strength: ≥300Mpa   

 

Alumina heaters were developed based on ceramic lamination technologies, which are

mainly used for highly reliable IC ceramic packages. Thus, these are widely used as a new

type of heater in a variety of markets such as automotive, kerosene & gas equipment and

water heating.

 

We made every types of ceramic heating plate.

Customization is welcome here.