PVC Banner Welding Machine hot air welding type

I.Field of application

LC-15 smart type:Suitable for advertising industry,inkjet fabric,light box cloth,Knife cloth,mesh cloth PVC,PE hot melt plastic membranes welding process.

II.Main technical details

Rated voltage: AC110-240V Frequency: 50-60Hz

Power : 1000-3000W Temperature scope: 0-500°C

Speed scope: 1-15m/min Sepcification: 41*25*20cm

Weight: 15-20Kg Splicing width: 2-5cm

III.Characterics

No glue splicing,temperature abjustable speed,with a feedback temperature sensor,real-time monitoring and control temperature (usually the market adjusted voltage,adjust the wind speed,temperature is not constant).No matter how long screen,welding screen effect will not change.

IV.Operation procedures

1.First of all,lighten up the spraying cloth,target the sew.(2-5cm),and fix the cloth on the ground with glue or tape (picture1) 

2.Insert the power(picture),turn the handle to the left,till the spout is straight-line with the wheel.The turn the black button to the right,adjust the speed,usually put it on 4(picture 2).After adjust the speed,turn the handle to the right till the spout leave the ground.Then it stops.

3.Adjust the temperature.Turn on the temperature button(turn the golden button to the right,it make the voice"Ka".Then press the temperature up and down button(picture 3),adjust the temperature according to the thickness and durable of the cloth,usually put it between300°C and 350°C.Or you can put some materials in the spout,if the materials melt immediately and shouldn't scorch.It is the proper temperature.

4.After adjust the temperature and speed,put the edge of the right-wheel in a level with the edge of sew.When the actual temperture reach to your set temperature,turn the handle to the left till the spout insert into the sew totally.(picture 4)The machine beginstowalk.Splicing begins.

5.During splicing,if the spout melt the spraying cloth.First you should turn black button to the right a little,or you can turn down the temperature.(choose one from the tow ways) in that way,it won't melt the cloth.But you shouldn't turn the button in very urgent speed,or it will make the machine can't weld or damage the cloth.

6.Before using,please find a proper temperature and speed.If slow,it will damage the cloth;if fast,it may stick not sso fasten,so it is important to adjust the temperature and speed.

7.On the completion of splicing,turn the handle to the right,till the spout leave the spraying cloth totally.(picture 5).At this time,you can turn off the temperature button.But you couldn't turn off the power cord and the power button,in case the heat damage the heat gun,and make the machine couldn't work.You must wait till its actural temperature reach to the lowest.

8.Don't use the machine in wet weather.The working place must be dry and flat.Pay attention to the fire,the machine ,you should be responsible for the result yourself.

9.The warranty period is six months,heating elements are not in the warranty scope due to it being a repid-wear article,and we are only responsible for the supply of fitting ,but the cost is subject to the client.

10.Fitting equipped along with the machine include a source line of 10m,a piece of alternate heating element, a instrution book and a CD.

Welcome to our site, sincerely hope you have a good time in our site.