IEC 62560 Bending Moment Test Device
1. Introduction
The bending moment test device is applied to test the bending moment of the lamp at the lampholders, the value of bending moment shall not exceed the values given in below table. The test device can meet the test requirement of IEC60968-2015-02 clause 6.2 and IEC62560 clause 6.2.
Caps | Bending moment (Nm) | Mass (kg) |
B15d | 1 | / |
B22d | 2 | 1 |
E11 | 0.5 | / |
E12 | 0.5 | / |
E14 | 1 | / |
E17 | 1 | / |
E26 | 2 | / |
E27 | 2 | 1 |
E39 | 1 | / |
E40 | 1 | / |
GU10 | 0.1 | / |
GZ10 | 0.1 | / |
GX53 | 0.3 | / |
2. Parameter
Force gauge | Test range: 0-10Nm Resolution: 0.1Nm Accuracy: ±0.3% F.S. |
Lifting structure | Lifting range: 0-100mm Structure: linear guideway+manual wheeler |
Bending moment | L*N L: distance between the pivot line and the top of the lamp, measured by steel ruler N: force value, measured by digital force gauge |
Accessories | Digital force gauge, fixed blocks, steel ruler |
