Helmet Anti Drop off testing machine/Helmet stability testing/Helmet retention detaching testing machine for IS 4151 ECE R22.05
Negotiable
Min.Order:1
Customized High-precision Test Helmet UV Aging Room That Meets the Test Standards
Helmet High Temperature Testing Chamber/Programmable temperature and humidty testing machine
High Precision According To Senll Sa/k 2010 Dot218 Standard Helmet Mask High Speed Impact Tester
Manufacturers Can Customize The Precise Programming Test Temperature And Humidity Testing Machine
High-precision Measurement Of Humidity And Heat Testing Machine (environmental Box)
1078 Test Bike Helmet Impact Shock Absorption Capacity Helmet Testing Machine
Helmet Anti Drop off testing machine / Helmet stability testing / Helmet retention detaching testing machine for IS 4151 ECE R22.05
Purpose
It's used for helmet anti drop off testing , stability testing and retention detaching testing etc
Testing standard
It's suit for IS 4151 and ECE R22.05 testing standard
The Main Technical specifications
Product Name | helmet anti drop off testing machine / helmet stability testing / helmet retention detaching testing machine |
Testing standard | IS 4151 , ECE R22.05 testing standard |
The mass of initial load | 3kg±0.1kg |
The mass of falling weight | 10kg±0.01kg |
Falling height | 0.5m±0.01m |
Measurement ways | Manual |
Electricity | 220V 50HZ |
Testing theory | vertical falling |
Testing procedure
1.The helmet previously conditioned at ambient temperatuer and hygrometry ,shall be placed on and secured to the appropriate headform
2. A device to guide and release a falling total mass being 3kg±0.1kg is hooked on to the rear part of the shell in the median vertical plane of the helmet
3.The falling mass of 10kg±0.01kg is then released and dropped in a guided free fall from a height of 0.5m±0.01m, the guiding device shall be such as to ensure that the impact speed is not less than 95 percent of the theoretical speed
Determine Standard
After the test the angle between the reference line situated on the shell of the helmet and the reference plane of the headform shall not exceed 30°