IEC60061-3: 7006-19A-1 BAU15s Go Gauge for Cap on Finished Lamp
PURPOSE: To check dimensions A max., D1 min., D1 max., N min. and the angular displacement of the pins of caps BAU15s on finished lamps.
TESTING: The cap shall enter the gauge at surface W until the pins have passed through the a lots Q. The cap is then turned through a small angle and is pushed so that the pins are in close contact with surface S. In this position, the contact making surface shall not be below surface X nor shall it project ensure interchangeability of the caps in the holder.
