Portable solar system for home use with LED lamps CE&ROHS Approved
Dear Users:
Thank you for selecting our products. Please read this manual carefully before you use this product.
Overview:
The main features and characteristic are listed below
- High efficiency solar panel with High Lumen LED bulb to get full use of solar energy.
- Three LED output interface prolong lifetime of LED.
- Built-in high quality Lithium battery.
- USB output maximum power 5V 1A.
- Complete accessories, simple to install and use...
Important Safety Information
n This product is not water-proof, prohibit installation outside, wet or high humid condition.
n Please keep the environment ventilation, away from high temperature, flammable and explosive.
n Please full charged battery in the first time using. Please turn off the power switch if do not use for a long time. Please insure every three months full charged battery once.
n Prohibit accessing solar panels or LED bulb which is unknown specification or over scope the product capacity.
n When the solar panel collecting dust too much, please promptly removed, or it can reduce the efficiency of electricity generating from solar panel.
Installation and Using Instruction
- The host installation should be selected in ventilated and dry and where is no direct sunlight position.
- Select M4 screw which screw cap diameter less than 7mm, fixed the host on the wall or other flat surface.
- The installation of solar panel should be outside under sunshine with any shading.
- Plug in the solar panel into Solar symbol interface, if the sun is full at this time the Red LED indicator will be bright, when the battery is full charged, the LED indicator will be green.
- Hang on the LED bulb in the room, plug in the connector to DC output with three BULB symbol. Turn on the switch of host, the green power indicator will be bright, then turn on the switch of cable, the LED could be lighting at this time.
- The USB interface could charge mobiles.
Common Fault and Handling
- The charging indicator is not bright, please check the connection of solar panel at correct interface, the solar panel position under sunshine or not.
- No output from load:
l The LED bulb plug in corresponding interface
l The switch of Host or switch of cable is turn on
l Battery low, please full charged battery then to use.
Technical data:
Model |
|
System Voltage | 3.7V/7.4V |
Max. Input Voltage of solar panel | 7V;×2 7.4V |
Max. charge current | 1.5A |
LED port output current | 280mA ×3 |
USB output | 5V/1A |
Low voltage disconnection | 2.5V ;×2 7.4V |
Low voltage reconnection | 3V ;×2 7.4V |
Over charge | 4.2V ;×2 7.4V |
Over charge recovery | 4.08V ;×2 7.4V |
Working Temperature | -10c---+45c |
Waterproof grade | IP32 |
Size | 163 mm×110 mm×31mm |