Hydraulic Rubber Hose Crimping Machine Exporter/Rubber Pipe Locking Machine Seller

Specifications

Hydraulic Rubber Hose Crimping Machine Exporter/Rubber Pipe Locking Machine Seller

The profile  (Two-in-One, one machine two functions, both inserting hose tails and crimping hose ferruels ):

Hydraulic hose crimping machine(Also can be called rubber  tubes locking machine,  rubber  tubes pressing machine, rubber tubes crimping machine, high  pressure  hose crimping  machine, tube locking machine, and so on.) is a kind of device which is used  to lock  and  press  the fitting assembly to the industrial rubber hose. It can force  contractility through  the moulds  to press and crimp the metal joints on the matching rubber tubes firmly.  Pressing and locking  lots of kinds of hoses,such as highlow pressure hose, gas hose, water hose, concrete hose, and also with cable joints, the machine is widely used on construction machinery,  house hold appliances and welding and cutting  equipment industries. 

As the market growing up faster and faster now, we produce different kinds of hose crimping machines, with the strength for the kind of concrete rubber hose. Both spiral steel wired hose and spiral textile hose type, from size 1.5” up to 5”, becomes more and more popular.

The advantage :

import components, low noise, long serving life.

widely crimping range

high pressure, easily assembling and operation

3.Wiht toolbx, workbench and quick change tools

SPECIFICATIONS:

Specifications:
Crimping range:from DN38mm up to DN 125
Maximum hose ID: 5″(inch)
Suitable hoses: concrete rubber hoses
Operating mode: manual, automatic
Motor: 7.6kw, 415V/380V/220V, 50Hz
Dies supplied: 11 sets(1.5”(1set),2”(2sets),2.5” (2sets),3” (2sets),4” (2sets),5” (2sets) )
Additional dies: Available
Weight: 908kg
Dimensions (L×W×H): 1200×1200×1500(mm)

Warranties:

 Email us, and talk more! 

Operations:

Based on the size of the rubber hose to be buckled, select suitable mould as per the technical parameter reference table of the locking pipe and mount it on the mould base. Regulated well the scale position as per the data in the data in the table, the pipe locking can be done.

After pipe locking, use a vernier caliper to mease the outside diameter dimension of the pipe sleeve after buckling to see if it meets the reference table data of the parameter. If it does not meet the data, the scale shall be precisely regulated until it meets the requirements. Because the manufactures of the pipe sleeve are different, so, specific dimension, material, hardness etc are certainly not the same.

These factors would result different influences on the pipe locking result, therefore, the data in the table is only for reference, the detailed data take the pressure test as the basis.

SafetyNotice:

1. When buckling, make the joint to locate the mould center as much as Possible, the joint is not buckled on the hex nut.
2. Prevent tool and other foreign matter from entering the locking head.
3. After the work is finished for each time, the eight-block mould base Must be made to extend to the greatest extent, this can make the Spring to be at extension status. If not, the spring will be damage.
4. When working, the hand should not stretch into the locking head.
5. The power supply must be switched off when maintenance is done.

Packing Details: discharging some parts to make sure it can be loaded to a standard iron case for safety delivery