TDXE4602 2-Way Scene Module used with 2-Button or 4-Button Switch Panel

Specifications

TDXE4602 2-Way Scene Module used with 2-Button or 4-Button Switch Panel

Features

l          Bidirectional communication by power line in high speed

(Can send out max 32 address commands, and accept two address commands)

l          Ultra-slim design. Dimension:46X46X23mm

l          Easy use and quick setup. Voice prompt for learning.

l          Use noise filter circuit inside

l          Can use remote to make scene ON/OFF at module itself address

Technical Specification

l          Rated Voltage & Frequency: 220VAC±10%,50Hz

l          Static Power<0.5W

l          Operating Temperature  -10~50°C

l          Response Time for bidirectional signals≤ 2s

l         Need neutral wire inside the switch box

Installation (Need neutral wire inside the switch box) 

Connect and install it by the professional persons as the wiring diagram.

Avoid injury to people and products.

1. Shut off power.
2. Connection lines according to label on the module.

Module's "L" connects with Live wire.

Module's "N" connects with Neutral wire.

Black /Red /Blue/Yellow/Green lines are connected with 2-Button or 4-Button 

Connect and install it by the professional persons as the wiring diagram.

Avoid injury to people and products.

1.       Shut off power.

2.       Connection lines according to label on the module.

Module's "L" connects with Live wire.

Module's "N" connects with Neutral wire.

Black /Red /Blue/Yellow/Green lines are connected with 2-Button or 4-Button

1. switch

panel.

Black is common, Red is First Scene ON, Blue is First Scene OFF,

Yellow is Second Scene ON, Green is Second Scene OFF.

Note Don’t connect the exterior five wires with Neutral or Live wire.

Notice

1. The Micro Module will exit from setting status if no action is taken after 30 seconds. When exiting, buzzer long rings one time.
2. Press and hold the setup button on the module for 15 seconds will also delete all setting. At this time, buzzer will long ring one time.
3. The scene module doesn’t respond to Dimmer commands.

Operation

Connect with 2-Button or 4-Button traditional mechanical switch panel.

Both up and down pressing Scene on Button will make Scene ON

Both up and down pressing Scene off Button will make Scene OFF

1. When press Scene on Button (up or down), buzzer rings one time. Scene will be ON. When it finishes, buzzer will ring twice. If press this button again (up or down) when it is acting ON command, action ON will be stopped, and buzzer will ring twice.
2. When press Scene off Button (up or down), buzzer will ring one time after 0.5 second. Addresses in this scene will be ALL OFF. When it finishes, buzzer will ring twice. If press this button again (up or down) when it is acting OFF command, action OFF will be stopped, and buzzer will ring twice.