| 2088Industrial pressure transmitter | ky3002 |
| Measuring medium | Liquid and gas are non corrosive |
| Range | ‘-0.01-0-150Mpa |
| Overload pressure | 150% |
| Accuracy | 0.5%FS，0.2%FS |
| Failure pressure | 300% |
| Response time | ≤1ms |
| Service temperature | ‘-20-125℃ |
| Waterproof grade | IP66 |
| Power | 24VDC |
| Output | 4-20mA/HART/RS485 |
| Process interface | M20*1.5 |
The pressure transmitter shall be installed where the temperature gradient and temperature fluctuations are small, while avoiding vibration and shock.To ensure the transmitter connector seal, roll the sealing tape at the connector and tighten the transmitter.
The transmitter shall be directly installed at the measurement point, but the strongly corrosive or overheated medium shall not make contact with the transmitter, and shall use the pressure diversion pipe to transfer the pressure outlet medium pressure to the transmitter.
It is better to be installed to the place with little temperature fluctuate and avoid the vibration and concussion.To make sure the sealing of the connection part, it is better to wrap the adhesive tape before fixing the transmitter.
It should be installed on the measuring point but not to touch the medium with strong corrupt and high temperature.It is better to make a transition by a special pipe.
