Chongqing Xinfeng TDP Magnetic Infrared Ray Lamp with CE and FDA

Specifications

Chongqing Xinfeng TDP Magnetic Infrared Ray Lamp with CE and FDA

TECHNICAL PARAMETERS

Osram Infrared Bulb for Medical Utility:220V/250Wx1

Switch:220V/6Ax1

Electrical Resistance:R1.50K 1W x1

Electronic Contrl Panelx1

Light Indicator:LED x1

   Using the method to Lamp:

   1 Plug in power unit;

    2 Switch on the“POWER”button (light indicator still                    remains off);

   3 Cumulative working hours are displayed on screen;

   4 Start:

Press the“TIMING”button to set working hours as needed, e.g. 45:00(min:sec). Then push the“START/PAUSE”button(with red light on).For every second elapsed,the Timer counts down from starting time until when it reaches zero while Lamp shuts off after 5 beeping sound.Note that if timing is not in need.Just push the‘START/PAUSE’button to run the Lamp continuously.Screen displays“cont” in the mode. The“RESET”button functions the same under both circumstances (Timing and Non-timing)which shows 00:00 on screen

When being pressed.During any operating course, the Lamp stops working (which means paused) once the

   “START/PAUSE”button is pushed and it will continue working again when the“START/PAUSE”button is pressed later

   Temperature Setting:

   During any operating condition,press the“TIMING”button to adjust voltage (and temperature). Should the voltage be equal to the maximum quantity of power supply(the temperature reaches the highest then)when the“START/PAUSE”button is pushed.The Power output changes from one level to another for every pressing on the“TIMlNG”button. Here we provide three levels of circulating outputs which proportion the power

   supply into 100%,75%and 50%.The highest temperature realizes at the first level while

   the lowest one generates at the third level.

Radiating Position

   Straight radiation(pertaining to clinic applicable reference and acupuncture points illustration) on sick positions or related acupuncture points. One or more Lamps used for different position are approved.

Radiating Distance

   Should there be 20-30cm(8-12inch) between radiating skin and Lamp bulb.The surface temperature of hunan skin should remain around 40°C ( 104°F)or what makes the patients easy.

Radiating Period

   1to 2 times every day with 30 to 60 minutes every time is recommended. 7 to 10 days can be recognized as a therapy course whereas a 3-day break before a following course is appropriate. Should the long-run healthcare radiation be applicable when patients’states demand

MORE RANGES

ACCESSRIES&CERTIFICATES

PACKING

OUR SUCCESSFUL EXHIBITION