Advantages of CJMFH 1300/1600-I:
1) Saves the PE plate material as well as the unrolling and warming up
consumable
2) Easy operation: it doesn't need to roll the PE plate
3) High rate of finished products: one percent higher than CJMFH 1300/1600-II
CJMFH 1300/1600-II:
1) Advantages:
a) High speed of finishing products: reaches 4-5m/min because it's not
subjected to the PE extruding machine's control, thus its cost for each
square is comparatively low
b) High yield rate, because all the unqualified goods can be reproduced until
it's qualified
2) Disadvantage: high cost in warming up the extruding machine and rolling up
the PE plates
Thesetwo kinds of lines are the same from the preset macromolecule film tothe finished products plat. They are automatic to set the PE plate ofcertain strength
to the preset annulus to make the film combined with the plate. Then this
combined material will be sent to be combined with the pre-warmed aluminum roll.
After several times' combination and level off, and if it's molded, it's then sent
to the cool oven for cooling. Then the cooled plat will be covered by a protecting
coat and sent to the trimming machine then cut according to the customer's requirements.
Consideringof the above advantages and disadvantages, we recommend the customer toanalyze his own condition and the benefits so as to choose the properstyle of this machine. On the other hand, our company is capable ofdesigning new machines according to customers' requirements
