HM-10 CC2540 CC2541 4.0 BLE to Uart transceiver Module
If you are in need of such a 4.0 BLE module, MCU can be set up, also can controlled by a remote BLE device for setting,can transfer data, and can remotely control 10 PIO pins,so,the best choice is HM-10 BLE module. can replace HC-05, HC-06, HC-07 etc.
HM-10 cc2541 680X680.jpg
HM-10 can work with IOS, PC, Android 4.3 now.
Product features
1.Send and receive no bytes limit
2.The power can be adjusted -23dbm, -6dbm, 0dbm, 6dbm, can modify through AT Command AT+POWE
3.Long range, Open space have 100 Meters
4.Low Power: Only 0.5 mA for standby, Active 8.5 mA, support auto sleep.
5.Central & Peripheral in one
6.UUID FFE0, FFE1
7.Support serial port update firmware (add in V508)
AT Commanders (new version V502)
AT (Test command)
AT+BAUD (Query/Set Baud rate)
AT+PARI (Query/Set parity)
AT+STOP (Query/Set stop bit)
AT+UART (Query/Set uart rate,parity, stop bit)
AT+PIO (Query/Set PIO pins status Long command)
AT+NAME (Query/Set device friendly name)
AT+PASS (Query/Set device password code)
AT+RENEW (Reset device settings)
AT+RESET (Restart device)
AT+ROLE (Query/Set device mode, Master or Slave)
AT+CLEAR (Clear remote device address if has)
AT+VERS? (Show software version information)
AT+HELP (Show help information)
AT+RADD (Query remote device address)
AT+LADD (Query self address)
AT+IMME (Query/Set Whether the device boot immediately)
AT+WORK (if device not working, start work, use with AT+IMME command)
AT+TCON (Query/Set Try to connect remote times)
AT+TYPE (Query/Set device work type, transceiver mode or remote mode)
AT+START (Switch remote control mode to transceiver mode)
AT+FILT (Query/Set device filter when device searching)
AT+COD (Query/Set Class of Device. eg: phone, headset etc.)