Environmental-friendly the waste car battery recycling line

Specifications

The car battery recycling line

Battery recycling plant is based on the advanced and reasonable mechanism process that can separate the LEAD from lead battery. The final output product of this process is lead without any plastic inside. 

This process is an eco-friendly method instead of some polluted way that is based on burning and chemical processing. 

This battery recycling plant, with working process from inlet of waste battery to recycled LEAD, consists of 1 battery cutter, 1 intelligent shredder MX800, 1belt conveyor, 1 special granulator, 1 feeding slot, 1 plastic washer, 1 spiral chute, 1 vibrating screen, 1 metal separator.

Waste lead acid battery resource recycling equipment

 1.      Technique Introduction
It is an integrative equipment for lead acid batteries grinding and metal and non-metal separation. At first batteries are grinding and collect acid water by automatic machine. Then scrap batteries go to grinding and separation equipment. Finally metal and plastic can be obtained. This equipment has been combined the most advanced grinding and separation techniques in the world and adopted unique process technique. It works in enclosed environment and no waste water, drogs and poisonous gas give off during production. 
 
2.      Technical Specifications:
Model No. MX 800

Process Capacity (kg/hr) 1000kg

Dimension (L*W*H)/m 24x6x3
Power Consumption (kw) 380v/102KW

Operators 3                                                     
Metal Recovery Rate 97%-99%    
Metal Content of Non-metal Powder <1%    
Granularity of Metal (mm) 2-40mm   
Granularity of Non-metal (mm) 2-40mm

 
3.      Environmental Protection Standards
A.      Emitted exhaust gas consists with secondary standard of “Emission Standard of Air Pollutant” (GB16297-1996)
B.      The equipment uses negative pressure transportation, no dust in operation environment. Slight dust leak in the outlet can be manually controlled.  

 
4.      Characteristics and Benefits
A.      The coarse crush can grind batteries and collect acid water
B.      National Environment Protection Standard achieved. No dust leak and no secondary pollution such as waste water and exhaust gas.
C.     Low energy consumption but high production.
D.     High metal recovery rate which reaches 96%-98%. Metal content in non-metal powder is less than 1%.

 
5.  The acid water disposal (reference)

A,Regulating tank, mainly used for adjusting the water quality and making the waste lead dust and sediment, can be effective precipitation and collection. Regulating tank need install level controller and pump.

B, pH regulation and reaction pool: intermittent reactor operation and regulation of pH. Acid water will flow into reaction tank by pump. To control the water level, lye pump starts running at the same time. pH regulated by pH automatic control instrument control.

C, Coagulation and sedimentation: coagulation and sedimentation are together. Concrete is from lifting pipeline to concrete tank, pump will draw the water into concrete groove from reaction pool, flocculant use PAC, coagulant using PAM,

D, Adsorption, this project uses activated carbon adsorption to treat the lead water once again, and removal of tail water with floats.

E, The tail water system, the clean water tank, water level controller and pump, can reuse water in workroom and discharge.

Flow chart:

Manufactory photos

Machine photos

1,battery butting machine and collecting acid water

2, Coarse crusher

3, Fine crusher,vibration separator and work platform

3, Slag pool,plastic washer and spiral belt

4, Metal separator and paper scrap separator

Obtaining lead granules and plastic granules

Contact information