Product Application
Horizontal Plough Shear Mixer is a new type of mixing equipment with high efficiency, good mixing effect and, low energy consumption, low pollution. It is widely used for mixing materials such as powder, liquid, granule, especially for materials with high density or need to be crushed or grind such as cement ,fertilizer or detergent powder.
One. Descriptive abstract:
The Horizontal Ribbon Mixer consist of U-Shape tank, spiral and drive parts. The spiral is dual structure. Outer spiral make the material move from the sides to the center of the tank and the inner screw conveyor the material from the center to the sides to get the convective mixing. Our TDPM series Ribbon mixer can mix many kinds material especially for the powder and granular which with stick or cohesion character, or add a little liquid and paste material into powder and granular material. The mixture effect is high. The cover of the tank can be made as open in order to cleaning and change parts easily.
Two. Characteristics:
1. High mixing uniformity. Ribbon with disconnected structure produced greater shear motion as opposed to a continuous ribbon, allows the formation of more material in the vortex flow, speed up the mixing speed, improved blend uniformity.
2. High speed. TDPM series mixer with Horizontal tank, single shaft with dual spiral symmetry circle structure. The disconnected ribbon of the mixer can make the material mixed with more high speed.
3. Uniformity in short time. Dual spiral symmetry circle structure. Outer spiral make the material move from the sides to the center of the tank and the inner screw conveyor the material from the center to the sides to get the convective mixing.
5 . Durable & stable. All the material except the motor is made of Stainless Steel 304.
6. TDPM series mixer is with CE certificate.
1. The top cover of the U Shape tank has the entrance for material. It can be also designed with spray or add liquid device according the customer’s needs.
2. This mixer also can be designed with the function to keep cold or heat. Add one layer outside the tank and put into medium into the interlayer to get the mixing material cold or heat. Usually use water for cool and hot steam or use electrical for heat
Four. Configuration List：
Five. Dimension Drawing:
Six. Parts
Outer spiral make the material move from the sides to the center of the tank and the inner screw conveyor the material from the center to the sides to get the convective mixing
Pneumatic valve control discharge hole
No material deposit and without dead angle when mixing