1 forming craft
De-coiler----hole punching----roll forming----positioning and cutting----collection table
2 equipment consist
The line consists with de-coiler , hole punching and punching mould section, main roll forming machine, positioning and cutting device, collection table and electric control panel etc.
3 main part parameters
3.1 de-coiler
material width: 100mm
max. loading 1000kg
coil inner diameter 460~510mm
coil outer diameter 1200mm
3.2 front punching section
Function: Considered after the middle hole the part formation shuts off easily to compress, therefore will shut off before the formation the spot hole part the blanking will fall first.
Material of punching mould Cr12.
3.3 main roll forming machine
Forming stations: 10 stations
Max. feeding width: 100mm
Max. thickness of raw material: 0.6mm
Forming height: 20mm
Diameter of the roller shaft: Ā40 mm
Material of the roller : Gcr15, quenching treatment, HRC58-62°
Drive type: 4kw frequency change motor, ZQ250 reducer .
3.4 Hydraulic cutting: hydraulic pump 5.5kw
Collection table : roller type length 2m
3.5Electric control system: PLC control
