Low Noise Professional Air Caulking Gun/Automatic Silicone Applicator

Specifications

 Name: Low Noise Professional Air Caulking Gun/Automatic Silicone Applicator

1.Features:

This Pneumatic caulking gun is a professional applicator tool and it is designed and developed by the professional group. You can work with less force by this new model caulking gun and do a wonderful work with it.

This type of automatic silicone applicator is suitable for DIY and professional use, suitable for 310ml-600ml sausage glue. It is widely used in building decoration, electronic appliances, motor vehicles and parts, ships, container industries and so on.

2.Our advantages

Convenient International Transportation: Adjacent to Shanghai Port and Ningbo Port.

Timely delivery-100% delivery on time..

Quality assurance.

Actively cooperate with customers, to help solve the problem in time.

3. Directions

1, Pierce or cut off the front tip of the cartridge, remove the front cap from the applicator and insert

the cartridge into the barrel.

Tighten the front cap to provide an air-tight seal between the rear part of the cartridge and the     rubber washer.(Note: Air leaks may occur if the cartridge edge is damaged).

2, Connect the air caulking gun to the air hose then connect with the gas source equipment(air compressor).

3, Adjust the air regulator to a appropriate pressure;

4, by pulling the trigger, a cushion of the compressed air builds up inside the applicator to initiate the flow of sealant.

5, on releasing the trigger, the sealant flow ceased as the compressed air escapes rapidly with less noise at the rear part of the gun.

6, Rotate the regulator knob clockwise will increase the flow of sealant, and rotate the regulator knob anti-clockwise will reduce the flow of the sealant.

7, always disconnect the air hose after use or when replacing the air hose.

8, front caps should always be securely tightened during using to ensure safety.

9, clean up all the leftovers inside the barrel or outside the barrel after using

4.caution

1, make sure the front cap is securely tightened before using.

2, always disconnect the air hose after using or when replacing silicone sealant.

3, don't take apart the parts without any guide.

4, don't aim the barrel at people or animals when pulling the trigger.

5, it is recommended that safety spectacles are worn when using all pneumatic tools.

5.Disclaimer:

Considering the various aspects, we can not guarantee this instruction has included all the possible cases. Pls make sure to read the instruction first and under special guidance for the first use. We will not bear the responsiblity for misused or abused.

About Us

Processing Sketch

Other Series

F.A.Q