STMicroelectronics STLINK-V3SET Debugger/Programmer Probe is a modular stand-alone probe that features an embed STM32 32-bit microcontroller based on the Arm® Cortex®62M processor. The STLINK-V3 is a composite USB device similar to the ST-LINK/V2-X versions. It features mass storage, Virtual COM port, and the ST proprietary debug interface. It can also present a bridge interface.
FEATURES
Stand-alone probe with modular extensions
Self-powered through a USB connector (Micro-B)
USB 2.0 high-speed compatible interface
Direct firmware update support (DFU)
JTAG/serial wire debugging (SWD) specific features:
3V to 3.6V application voltage support and 5V tolerant inputs
Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27mm pitch)
JTAG communication support
SWD and serial wire viewer (SWV) communication support
SWIM specific features (only available with adapter board MB1440):
1.65V to 5.5V application voltage support
SWIM header (2.54mm pitch)
SWIM low-speed and high-speed modes support
Virtual COM port (VCP) specific features:
3V to 3.6V application voltage support on the UART interface and 5V tolerant inputs
VCP frequency up to 15MHz
Available on STDC14 debug connector (not available on MIPI10)
Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features:
3V to 3.6V application voltage support and 5V tolerant inputs
Signals available on adapter board only (MB1440)
Drag-and-drop Flash programming
Two color LEDs: communication, power
