Tape Feeder; 12;16 mm; Splice sensing; Type A，
Each of Feeder's components affects the way the machine picks up components. Here are a few common areas of damage. What can we do about them?
Part: Beak, cover (roll material cover) , front cover, safety buckle, etc. Are Wear and tear phenomenon, a little not obvious.
Feeder doesn't work in the following ways:
. Don't roll the tape
Is the beak or the inner cover wear these two, the identification method is to use the hand to step-by-step speed down the inner cover reverse push, the inner cover can be reversed, indicating wear. We can usually see it with our eyes.
. Throwing components (for feeder cases only)
The main thing is the location of the material, the feeder cover, which affects throwing components happen. Location: Use Good Feeder to adjust the vision in the calibrator, good Ng feeder to compare. (See Below picture 1) to adjust the feeder's head to the top right to make it look better than the previous feeder (left or right doesn't matter) . Tape guide: mainly wear and tear, not match. What's necessary is to put on the right one. If you don't have an accessory for exchange, use pliers to bend the outside of a tape guide inward so it sticks firmly.(picture 2)
The next time we'll talk about the next two points, they're especially important, so we don't have to worry about feeder not being able to fix it in time.
Feeder spare parts in stock:
COMB N210154807AB
LEVER KXFA1NKAA00
SPRING KXF0DYUFA01
LEVER N210029790AA
ROLLER KXFA1LPBA00
PIN KXFA1LTAA00
LEVER N210038151AA
PIN KXFA1KAAA00
PRESSER-COVER N610090959AA
CLICK KXFW1KWLA00
TAPE GUIDE SENS KXFW1KXLA00
SENSOR N510037013AA
WASHER N510018477AA
SCREW N510002401AA
COVER KXFA1N6BA00
COVER KXFA1PR1A00
COVER KXFA1N8BA01