250KG Forging Hammer

Specifications

1. C41-250KG Pneumatic Forging Hammer is widely used with flat die or special die for various forging works,such as drawing-out, upsetting, punching, chiseling, forging, welding, bending and twisting. It is also used for open die forging bolster dies.

   Because this Pneumatic Forging Hammer doesn’t use steam and compressing air,so it doesn’t need to install steam boiler,air compressor and air or steam pipe.Therefore you only need to invest less fund and time for establishing new factory.It is economically used by repair shop and large or small factory.

   Pneumatic Forging Hammer can’t be used for closed forging.Because the strong power would break off the hammer rod while used in closed die forging.

   Pneumatic Forging Hammer is operated with operating handle ,that could process six action cycle.----Idle run,lift hammer,press hammer light hit,wham and single hit,the workpiece must be put on the bottom anvil surface and opposite to the upper hammer die,only this could hit stably the workpiece to the shape you want.

2. Technical Specifications
   1	Weight of falling parts		Kg	250
   2	Max. hit energy		Kj	5.6
   3	Hit number		min -1	150
   4	Distance from bottom die surface to bottom surface of lead		mm	450
   5	Tup axis to hammer body		mm	430
   6	Dimension of top die surface		mm	220 X 100
   7	Dimension of bottom die surface		mm	220 X 100
   8	Distance from botton die surface to base		mm	750
   	Motor	Type	--	180L-4
   		Rate power	kw	22
   9		Speed	r.p.m	1470
   10	Overall dimension		mm	2875 X 1405 X 2570
   11	Anvil Weight		kg	~3000
   12	Total Weight		kg	~8000