IEC61032 The Standard Test Finger Probe (probe B)
Article NO.: BND-B
Specification:
The Standard Test Finger Probe / The Standard Test Knurled Finger Probe / Test Probe B / IP2X Protection Grade Probe
1, According to : IEC61032,IEC60950,IEC60335,IEC60529,IEC60045,IEC60884
2, The Standard Test Knurled Finger Probe is the necessary appliance to prevent electric shock for household and similar electrical problem
Technical Parameters:
1, Knurled Finger Diameter:12mm
2, Knurled Finger Length :80mm
3, Baffle Plate Diameter :50mm
4, Baffle Plate Length : 100mm
Application:
1, The joint part of The Standard Test Jointed Test Finger Probe can't touch the live parts or close to the dangerous parts, and 50 mm to 20 mm baffle plate cannot enter.
2, In the prevent electric shock test, wiring, power devices, and lighting devices are needed.
Note :
The Test Probe is made of precision stainless steel products, take and put down slightly when using, and pay attention to maintenance
Material of finger: heat-treated steel, for example.
Both joints of this finger can be bent through an angle of 90 ° but in one and the same direction only.
NOTE 1
Using the pin and groove solution is only one of the possible approaches in order to limit the bending angle to 90°. For this reason, dimensions and tolerances of these details are not given in the drawing. The actual design must insure a 90° bending angle with a 0° to + 10° tolerance.
NOTE 2
Dimensions in parentheses are for information only.
NOTE 3
The test finger is taken from IEC 60950-1, Figure 2A. That test finger is based on IEC 6103216), Figure 2,test
probe B. In some cases, the tolerances are different.
Products details:
Related Products: