4 E1 over Fiber Multiplexer

4E1 fiber optical multiplexer, is use the PDH fiber transmission technologies. The 2M (E1) interfaces can connect with the exchanger, light loop device and multi-diplexer directly to form the mircomidi or the special network. Complete alarm function for 4E1, it is stable and easy to maintenance, install and small in size. It has one digital service telephone.

Feartures:

• Offer 4X 2Mb/s digital interfaces

• The supervisory control interface implements centralized monitoring and export the monitor and control information of this port and opposite port.

• One link to service telephone for duty contract

• 220VAC & -48VDC power options and the positive and negative of DC-48V can be optional because there is the self-test circuit for the polarity inside th1e device

• Standard 19/9.5 inches rack, little volume, light weight, steady capacity and convenient setup

• Digital clock recovery circuit and digital smooth DPLL adopted for 2.048Mb/s port

• LED indicators

• Has 1+1 fiber protection for optional

• Power supply redundancy : AC220 and DC-48V or DC-24V combination

Specification:

Optical interface    
Optical wavelength: 850nm/1310nm for multi- mode optical interface,
1310nm/1550nm for single-mode optic interface
Optical interface: SC or FC
Receiving and dispatching module: >-6dBm
Optical receiver receiving sensitivity <-36 (BER<10):
Dynamic range receiving: >-30dB
Transmitting range: Multi-mode 2 Km, single-mode 40Km, single-mode 60 Km, single-mode 120Km
Vibration characteristic: Satisfies G.742 and the G.823 standard
E1 interface   
Interface code: HDB3 code
Line speed: 2.048Mbp/S ?50ppm
Interface standard: ITU-T G 703
Interface impedance: 75ohm/unbalanced or 120ohm/ balanced
Interface characteristic: supports rack (19 inches, 6U high), can reach up to 24 directions

Application 1:Optical Multiplexer point to point  

Application 2 :Optical Multiplexer central SNMP Management