Delivery Time:5-25 working days
Certification:CE RoHS
D10 Black CREE XP-G R5 6500k Professional Dive Lights , Durable Underwater Dive Torch
PRODUCT SPECIFICATIONS
| Model | D10 Diving Light |
| Bulb | CREE XP-G R5 LED (Max 340 Lumens) |
| Color temperature | 6500K |
| Three output levels | High> Low>Strobe |
| Runtime | High: 110 min, Low: 600 min, Strobe: 260 min |
| Reflector | Glossy Aluminum reflector |
| Lens | 8mm Polycarbonate Board |
| Body material | Durable aircraft-grade aluminum |
| Angle of light beam | 6° hot spot, 110° periphery |
| Surface treatment | Premium Type III hard-anodizing |
| Color | Black |
| Battery | CR123 *2 or 18650 Li- ion battery *1 |
| Circuit Protection | With battery over-discharging protection, polarity reversing protection |
| Operation voltage | 3V to 6V. |
| Waterproof | 100 meters underwater |
| Dimensions | 148(length)*23(dia. of end)*50mm (dia. of head) |
| Weight | 210grams (without battery); 260 grams (with battery) |
| Underwater Weight | 130 grams (with battery) |
| Impact resistance | 1.5M |
BATTERY INSTALLATION
Remove the tail by turning counter-clockwise. Remove used batteries and replace with fresh batteries as shown by the polarity stickers. Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.BATTERY CHARGING
Plug the charger in the wall power socket, the indicator light is green in the free-load status. Put the battery in the slot of the charger. The indicator light is red if the battery is not fully charged; it will turn green after fully charged. Take out the fully charged battery and use them in the diving light.ON/OFF
Turn the tail clockwise until the light activates. DO NOT OVERTIGHTEN.
To turn the light off, back off the tail counter-clockwise until the light goes off.
Continue to back off for approximately one full turn to eliminate the possibility of the light activating accidentally in storage. For underwater use, backing off too much will allow water to enter past the o-ring.
MODES CHANGING
Successive switch ON-OFF within two seconds to cycle through high, low, strobe.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
CAUTION
If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please remove the batteries during transportation to prevent it from misoperation.
WARRANTY RETURN POLICY
Please contact your local distributor or retailer for information on how to handle your warranty items.
REPLACEMENT PARTS
CAT# DESCRIPTION
D108 O-ring
D109 Lens
