Motor type | Output | Voltage | Load | Speed | Rated Torque | Efficiency |
KW | V | A | RPM | N.m | % | |
VOL-BL075B48 | 0.75 | 48 | 16.98 | 3000 | 2.39 | 92 |
VOL-BL1K0C48 | 1 | 48 | 24.5 | 2500 | 3.82 | 85 |
VOL-BL1K2C24 | 1.2 | 24 | 63.3 | 4200 | 2.73 | 79 |
VOL-BL1K2C36 | 1.2 | 36 | 39.7 | 2270 | 5.05 | 84 |
VOL-BL1K5C24 | 1.5 | 24 | 73.5 | 2590 | 5.53 | 85 |
VOL-BL1K5C72 | 1.5 | 72 | 23.5 | 3200 | 4.48 | 89 |
VIEW MORE PLS CONTACT US >>>
Q:Motor has been running then fails to start,what to do?
A:Likely cause: Fuse or circuit breaker is tripped.
What to do: Replace the fuse or reset the breaker.
Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip.
What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.
Likely cause: The brushes may be worn down too far and no longer make contact with the commutator.
What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.
Likely cause: Controller may be defective.
What to do: Verify voltage is coming out of the controller.
Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
What to do: Verify that the motor is wired correctly.
Likely cause: No output power from controller.
What to do: Measure voltage coming from the controller.
Likely cause: Motor is damaged and the armature is rubbing against the magnets.
What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.
Q: Motor takes too long to accelerate,what to do?
A: Likely cause: Motor controller not properly set.
What to do: Adjust the acceleration trim pot of the controller.
Likely cause: Brushes are worn.
What to do: Verify brush length.
Likely cause: Bearings may be defective.
What to do: Inspect bearings. Noisy or rough bearings should be replaced.
Q: Motor runs in the wrong direction,what to do?
A: Likely cause: Incorrect wiring
What to do: Interchange the two motor leads.
Q: Motor runs OK but has a clicking noise,what to do?
A: Likely cause: Suspect a burr on the commutator.
What to do: Remove burr from commutator using a commutator stone.
You May Like
- 7kw 12v 1000 48v 1500w compressor driver hair dryer brushless dc electric motor for rc quadcopt
- 72v 3hp 220v 72v 4kw ev boat outboard compact neodymium magnet electric brushless dc 4kw bldc motor
- 2.5kw 72v Hot sales high torque brushless servo dc motor
- 48 v 750 watt 30 volt 60v control airplane wind machin brushless dc motor for electr fan stand fan
- Good quality low cost 24v 3000rpm and 700w dc brushless servo motor
- 48V 1500w best quality made brushless BLDC dc motor in China for high torque
- 600w 3000rpm high speed low power DC brushed motor for industrial applications
- 1500rpm 220v 1kw Good quality Hot sales high torque brushless servo dc motor
- Custom 220v 2000rpm 1500w electrical car brushless dc motor
- 1500RPM 500W 36V high reliability brushless DC motor in China factory
Popular Searches
Find Similar Products By Category
You May Like
- 220v 3kw 4kw car neodymium magnet electric air brushless dc motor for golf cart
- 3000rpm and 1kw Durable Brushless Dc Motor driver with encoder
- Silent Long lifetime 220v 2kw brushless dc motor for Robotics and Automation
- 50nm 24v 200w 18 watt b5665m ebike wheel underwater brushless dc motor with home air purifier
- New design custom 1500rpm 3000w 380v brushless dc motor
- 48v 3000RPM superior high torque high efficient dc brushless motor
- 500w 1000w 2000w 1500rpm high torque brushless servo 48v dc motor
- High power 36v 220v 2500rpm 2000w brushless dc motor for auto
- 1500rpm 800w 24v high torque low speed brushless dc electric motor
- professional and hot sales high torque 110v brushless servo dc motor
- 110v 1200w 3000rpm dc servo brushless motor with encoder
- IP54 0.5KW 500rpm low noise high torque Brushless dc motor
- Durable 1500rpm and 400w driver Brushless DC Motor with encoder
- Long lifetime 12v 700w 3000rpm brushless dc motor
- high reliability 1500RPM 500W 48V brushless DC motor in China factory