SPECIFICATION
APPEARANCE Colorless to pale yellow liquid.
DENSITY(20 oC) g/cm3 1.02 – 1.07
PH(10% water solution) <2.5
SHELF LIFE
TWO YEARS
Controls iron staining and scale formation
Dissolved metals and minerals (such as iron, calcium, manganese and magnesium) in pool
water and corrosion of metal pool fittings will often cause staining and/or scaling.This product is used in
swimming pools to reduce scale formation in pumps and pool heaters, to eliminate plugging of filters
and to reduce iron staining.
Soluble metals can be inhibited from precipitation by sequestering/chelating agents that bind with the
colored metal ion to keep it in solution. Metal and Scale Remover sequesters the material causing
stains and scale and holds them in solution. Regular use of this product helps keep pool water clear
and the pool walls and plumbing in good condition. Use of Metal and Scale Remover as part of the pool
maintenance program will result not only in the control of scale, but also in the removal of existing
deposits. This product is also highly effective as a rust-control agent.
DIRECTIONS FOR USE
Maintain pool water in the pH range of 7.2 to 7.6, total alkalinity at 100 to 150 ppm and calcium
hardness at 100 to 275 ppm. If pH falls below 7.0, serious corrosion problems may result.
For best results, use Metal and Scale Remover in the evening with the pool pump and filter
operating overnight.
Add 500ML of Metal and Scale Remover per 40 tons of water by premixing into plastic pail of water
and then dispensing solution at deep end of the pool.
Cloudiness accompanied by white flakes may appear indicating that the product is working, the
cloudiness will eventually disappear.
MAINTENANCE TREATMENT
Follow all steps outlined above.
Every 4-5 days, add 60ML per 40 tons of pool water, to prevent stain and scale formation.
Note: In hard water areas where calcium hardness exceeds 300 ppm, it is advisable to double the
dosages listed above. However, DO NOT increase the dosages more than double for one
application.
