Drawing Machine for Copper Wires
Model: HT-250-17DT
HT-250-17DT Drawing Machine for Copper Wires is used to draw Φ3.5mm copper wire into φ0.4 - 1.6mm.
The line is consisted of the following main parts, i.e. the drawing machine, the annealer and the spooler, emulsion system, tooth wheel lubricating system, electrical control cabinet.
The electric control of the whole line is completely cabled and connected.
The cable connections are already prepared to comply with the necessities at the erection site. Before shipment the complete electric equipment will be checked in our works and be subject to a test run (without wire)
Technical data
Inlet diameter : Max.Φ 3.5 mm
Outlet diameter : Φ0.4-Φ 1.6mm
Drawing speed : max 1800m/min
Drawing passes : max 17
Exterior diameter of dies : Φ25mm &.Φ32mm
Area reduction : the final die is 18.6%, others are 25%
Diameter of drawing capstan : Max. Φ250mm
Diameter of finished capstan : Φ 250mm
Power of drawing main motor : AC55 kw
installed power : 330 kVA
normal electricity consumption : approx. 360 kWh
cooling water consumption : approx. 25 m3 /hr
Compressed air :12 -18 m3 /hr
Bobbin for spooler : PNDΦ500×Φ280×315
Operation direction : left to right (to be confirmed by customers)
Noise level :< 85 dbA (Except for main motor )
Line dimension (L X W X H) : approx.11000×4600×4500
Pictures
Certification
Please contact us for more information.
Please contact us for more information.