Specifications
rtv coating for insulator1.viscous liquid
2.potting in 6mm-2cm long tubes
3.good transparency,waterproof
4.22KG
LED K-5312T silicone high voltage insulator coating thermal insulation coating rtv coating for insulator
Features:
1) K-5312T is two-component, room cure silicone encapsulant.
2) It become transparent elastomer after cured, water and moisture proof, good transparency, and yellow resistance.
3) Apply in deep-section potting and fixing in 6mm~2cm.
4) Good adhesion to metals and mostly plastics(epoxy resin, polycarbonate, nitrile rubber, epdm)
APPLICATION:
Encapsulating and potting inLED module, general electronic components, PCB board, and beads in LED strip lights, led rigid bar light, etc.
PROPERTIES
Item | K-5312T(Transparent) | |
Uncured | Appearance | A: Clear transparent liquid B: Clear transparent liquid |
Viscosity(25°C, mpa.s) | A: 1000~2000 B: 5~10 | |
Density (25°C, g/cm3) | 1.10~1.05 | |
Mix Ratio(by weight) | A:B=100:10 | |
Controllable Time (25°C,min) | 60~90 | |
Mixed Viscosity(25°C, mpa.s) | 1000~2500 | |
Initial Curing Time(25°C,h) | 5~6 | |
Full Curing Time (25°C,h) | 24 | |
Cured
| (Shore A) Hardness(24h) | 15~25 |
Shear strength(mpa) | ≥0.5 | |
Thermal Conductivity(w/(m.k)) | 0.15 | |
Volume Resistivity(Ω.cm) | 1.0×1015 | |
Dielectric Strength(kv/mm-1) | ≥20 | |
Permittivity(100KHZ) | 2.9 | |
Dissipation Factor(100KHZ) | 1.0~ 3.0×10-3 | |
Directions:
1. Measurement
Fully mix component A before using, accurately weighing A part, and then put the Part B to mix with Par A by mix ratio. It can adjust by your own needs according to the specification.
2. Mixing
Put Part B in the bottle with Part A, evenly mix them immediately. And should tighten-sealed the Part B after using.
3. Pouring
Put the mixed glue evenly into the product which need encapsulate immediately.
4. Curing
The encapsulated components can be room cured, and it can put into next process after 10 to 24 hours full cure.
