Silicone Rubber for Adhesion to aluminum plate of LED lamp and radiators
This series are quick dry dealcoholization silicone rubber, single component type, with the advantages of neutral and non-corrosive, good insulation performance, moisture-proof, shock resistant, corona resistant and anti leakage of electricity, also with good heating conductive property and bonding positioning function, tensile strength is strong and adhesion property is good after curing, heat dissipation effect won’t lower because of gap contacting. They have good adhesion to metals and most of plastic, also with excellent resistance to cold and hot cycle performance after curing (-50---250℃).
Adhesion to the aluminum plate of LED lamp and radiators.
Filling and adhesion to the thyristor intelligent control module and radiator, high power electrical module and radiator.
Indicators | Specification | ||
Before Curing | Specific Gravity (g/cm³, 25℃) | 2.0-3.0 | |
Surface Curing Time (min, 25℃) | 1-10 | ||
After Curing | Mechanical Properties | Tensile Strength (Mpa) | ≥1.5 |
Elongation (%) | ≥60 | ||
Shear Strength (Mpa) | ≥1.5 | ||
Durometer (Shore A) | 50-80 | ||
Electrical Properties | Dielectric Constant (50Hz) | 3.0 | |
Dielectric Strength (KV/mm) | ≥18 | ||
Volume Resistivity (Ω.cm) | ≥1.0x1015 | ||
Thermal Conductivity (w/m.k) | 0.8-2.0 | ||
Operating Temperature Range (℃) | -50-250 | ||
Clean surface: clean the bonding surface
Application: cut outlet nozzle, extrude silicone rubber by glue gun, coating evenly immediately, then attach bonding surface
Curing: cured at room temperature in air
The remaining silicone rubber should be sealed, when using them again, if there is a little crust around nozzle, please remove it, it doesn’t affect the normal using.
Avoid skin and eye contact with using this product, in case of contacting skin, please wipe clean and rinse thoroughly with water. In case of contacting with eyes, rinse with a lot of water immediately and go to your nearest hospital for further care.
Please use the product in a well ventilated area.
2600ml/pc, 4pcs/carton
300ml/pc, 24pcs/carton
100ml/pc, 50pcs/carton or 100pcs/carton
Stored in a cool and dry place.
Handlled and transporated fall under general chemical products.
